A normal two-story wireless installation in chalet usually requires only a wireless router located in the center of the house. The new trend that Schaumuburg Computer Repair is facing is the new mega-demolition of houses that are all brick and have three floors with more than 4,000 square feet. The question is how do I give the customer the best wireless coverage at the lowest price. Standards Guide: 802.11b is old, don't use it. 802.11g runs at 54 mbps reported, but the actual performance is 22 mbps, it has a range greater than 802.11a. 802.11a is mainly used in areas where there are already many wireless access points, such as commercial offices. In addition, the 802.11a network may have multiple wireless shared access points because 802.11a has 8 non-overlapping channels, while 802.11g has only 3. 802.11n is only a draft at this point, so do not buy eraser products n. buy an 802.11g wireless access point with MIMO (Multi-in Multi out) technology. These access points are configured with two radios which allow them to send and receive at the same time. Stage One: Coverage Area: The definition of the home coverage area is very important because the definition of areas to be covered can affect the cost of the customers. We have many customers who do a lot of work in garages and separate basements, but many people use the fake airpods connection in a room. Therefore, the general rule is that the more areas that need wireless coverage, the higher the cost to the customer. Phase Two: Site Survey: Do a site survey to find out what other wireless networks are in the area. This is very important because it can affect whether you are installing an 802.11g wireless network or an 802.11a wireless network. If we do a site survey and find many 802.11g multi-channel wireless networks, it might be better to install an 802.11a wireless network running on a different frequency. Knowing which channels other networks are running is very important because each of your wireless access points must run on a different channel. The 802.11g standards have only three non-overlapping channels, which are 1.6 and 11, while the 802.11a has eight non-overlapping channels. The general rule to follow is that 802.11g is subject to more interference, but has an interval greater than 802.11a. Phase Three: Distribution System: Now you need to decide how to deploy your wireless network throughout your home. A wireless access point works like a wireless cable, so you still find a way to get a network connection to the wireless access point. You have three options: run network cables throughout the house (the worst option), configure the Ethernet power cord, or configure repeaters or wireless bridges. The performance of network cables is your last option because it requires drilling and time, which equals a higher cost. The Ethernet power cord is excellent because it converts its sockets into network cables. All you have to do is connect a power adapter through your wireless router connected to the internet and then plug adapters around the house where you need to connect the wireless access points. Then your last option is to configure wireless repeaters to extend your original signal throughout your home. Phase Four: Location of Access Points: Your first access points should be in the most central parts of the house with complementary wireless access points located in difficult to reach areas. Keep wireless access points away from large metal objects, and if the wireless access point cannot be located in a central location, use directional antennas to point the wireless signal internally instead of outside. Phase Five: Wireless Access Point Configuration: Your site survey has revealed that 99% of people buying a Best Buy wireless access point connect it and leave all the default values. This means your SSID is linksys and the wireless router / access point is on channel 6. Our largest home wireless network needs two to three wireless access points, so we configure our first two wireless access points in channels 1 and 11. If needed for a third party, you can use channel 6; just make sure that the user connections are not interrupted after configuring the wireless clients. Next, name your wireless network (SSID). Choose a dark name like home, a color or something that can't connect the network to the family.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2021
Categories |